SICK WS14-2 Manual De Operación página 6

9 Disassembly and disposal
8016167.YFQ1 | SICK
Subject to change without notice
LED indicator/fault pattern /
LED indicator/fault pattern
Green LED does not light up /
Green LED does not light up
Green LED lights up, no output
signal when object is detec‐
ted /
Green LED lights up, no output
signal when object is detected
Yellow LED flashes /
Yellow LED flashes
Yellow LED lights up, no object
in the path of the beam /
Yellow LED lights up, no object
in the path of the beam
The sensor must be disposed of according to the applicable country-specific regulati‐
ons. Efforts should be made during the disposal process to recycle the constituent
materials (particularly precious metals).
DISASSEMBLY AND DISPOSAL
Cause /
Cause
Sensor is faulty /
Sensor is faulty
Test input (TI) is not connec‐
ted properly /
Test input (TI) is not connec‐
ted properly
Sensor is still ready for opera‐
tion, but the operating conditi‐
ons are not ideal /
Sensor is still ready for opera‐
tion, but the operating conditi‐
ons are not ideal
The beam of light of a photo‐
electric through-beam sensor
hits the receiver of another
(neighboring) photoelectric
through-beam sensor /
The beam of light of a photo‐
electric through-beam sensor
hits the receiver of another
(neighboring) photoelectric
through-beam sensor
Measures /
Measures
If the power supply is OK,
replace the sensor /
If the power supply is OK,
replace the sensor
See the note on connecting
the TI /
See the note on connecting
the TI
Check the operating conditi‐
ons: Fully align the beam of
light (light spot) with the recei‐
ver. / Clean the optical surfa‐
ces . / Readjust the sensitivity
(potentiometer) / If the poten‐
tiometer is set to the max.
sensing range: Reduce the
distance between the sender
and the receiver, and check
against graphic H. / Check
sensing range and adjust if
necessary; see graphic H. /
Check the operating conditi‐
ons: Fully align the beam of
light (light spot) with the recei‐
ver. / Clean the optical surfa‐
ces . / Readjust the sensitivity
(potentiometer) / If the poten‐
tiometer is set to the max.
sensing range: Reduce the
distance between the sender
and the receiver, and check
against graphic H. / Check
sensing range and adjust if
necessary; see graphic H.
Swap the sender and receiver
arrangement at every
second photoelectric through-
beam sensor and ensure that
there is sufficient distance
between the through-beam
photoelectric sensors /
Swap the sender and receiver
arrangement at every
second photoelectric through-
beam sensor and ensure that
there is sufficient distance
between the through-beam
photoelectric sensors
9
5