Automatic Shutdown - Dentsply Sirona ProPex II Manual Del Usuario

Step-by-Step Instructions
(3)
(4)
(5)
If measurement cable is connected to ProPex
cycle, the device switches automatically to normal operation mode.
6.8

Automatic Shutdown

ProPex
advisable, however, to manually switch off equipment after
measurement by simply pressing the
B EN PIIL DFU WEB / Rev.07 / 02-2018 (Old ZF 190292.EN)
During Demo cycle device operating sequence is shown on
the screen. Press
button again to resume.
When Demo cycle is completed, it is repeated automatically
until interrupted by the operator.
To exit Demo mode press
seconds until a beep sounds.
®
II automatically shuts down after 5 minutes without use. It is
button to pause the simulation; press
button and hold it for about 2
key (On/Off).
®
II during Demo
19/48