Electrical Installation - SOMFY Dexxo Smart 800 io Instrucciones De Seguridad

Dexxo Smart 800 io / Dexxo Smart 1000 io
Illustration 1: Mechanical protection
Illustration 2: Safety distance
1.5

Electrical installation

DANGER
The installation of the power supply must comply
with the standards in force in the country in which
the motorisation is installed, and must be carried
out by qualified personnel.
The power line must be exclusively reserved for the
motorisation and equipped with protection, com-
prising:
a 10 A fuse or breaker,
and a differential type device (30 mA).
An all-pole power supply cut-off device must be
provided.
It is recommended that a lightning conductor be in-
stalled (maximum residual voltage 2 kV).
Cable feed
Underground cables must be equipped with a protective
sheath with a sufficient diameter to contain the motor cable
and the accessories cables.
For overground cables, use a cable duct that will withstand
the weight of the vehicles (ref. 2400484).
1.6 Safety instructions relating to installation
WARNING
Before installing the motorisation, remove any un-
necessary cords or chains and deactivate any locking
device (bolt) which is not required for motorised
operation.
DANGER
Do not connect the motorisation to a power source
before installation is complete.
WARNING
Modifying any of the components in this kit or using
additional components not recommended in this
manual is strictly prohibited.
Monitor the door as it moves and keep people away from it
until installation is complete.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Do not use adhesive to mount the motorisation.
Install the internal manual back release device at a height of
less than 1.8 m.
Permanently affix the label concerning the manual back re-
lease device near its actuator.
WARNING
Take care when using the manual back release
device as an open door can suddenly drop if the
springs are weak, broken, or incorrectly balanced.
CAUTION
Install any fixed control device at a height of less
than 1.5 m and within sight of the door, but away
from moving parts.
After installation, ensure that:
• the mechanism is correctly set
• the manual back release device is operating correctly
• the motorisation changes direction when the door en-
counters an object 50 mm high on the ground.
Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during installa-
tion.
For manoeuvring, drilling and welding operations, wear ap-
propriate protection (special glasses, gloves, ear protection,
etc.).
1.7 Regulations
Somfy declares that, when used in accordance with these
instructions, the product described in these instructions
complies with the essential requirements of the applicable
European directives, and in particular Machinery Directive
2006/42/EC and Radio Equipment Directive 2014/53/EU.
The full text of the EC declaration of conformity is available
at the following website: www.somfy.com/ce. Philippe
Geoffroy, Regulations Manager, Cluses.
1.8 Assistance
You may encounter difficulties or have questions when in-
stalling your motorisation.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions.
Internet: www.somfy.com
EN
7