Adjusting The Headrest - CYBEX gold SIRONA SX2 i-Size Guia Del Usuario

The car seat can also be used without the L.S.P. in use, if there is not
��
enough space in the vehicle.
EN
REMOVAL FROM THE VEHICLE
1. Unlock the ISOFIX-Locking arms (5) on both sides by pressing the ISOFIX-
Release buttons (4) and at the same time pulling them back.
2. Pull out the car seat from the ISOFIX-Anchorage points (6).
3. Remove the car seat and slide the ISOFIX-Locking arms (5) completely
back into their transport positions.
4. Push the Load leg (3) back into its original position and then fold it in to
save space.

ADJUSTING THE HEADREST

The adjustable Headrest (13) can be adjusted by using the Headrest
adjustment handle (14) at the back of the Headrest (13). When adjusting the
headrest ensure that no more than 2 cm (approx. 2 finger's width) remain
between the child's shoulders and the headrest.
ROTATION FUNCTION
Pull the Position adjustment handle (15) on the front of the seat and bring it
into an upright position. Now you can turn the seat.
��
We recommend to deactivate the L.S.P. before turning the seat.
Before starting your journey, make sure that the seat is properly locked into
place.
ADJUSTING THE RECLINE POSITION
To adjust the car seat to the desired recline position, press the Position
adjustment handle (15) on the front of the car seat.
We recommend using the flattest lying position for children who are not yet
��
able to sit upright independently.
Always make sure that the car seat audibly clicks into place when adjusting
��
it to either the lying or sitting position.
8
SECURING THE CHILD
1. Rotate the seat to the boarding position.
2. Press the Belt adjustment button (16) and pull both Shoulder belts (17) at the
same time to loosen them.
3. Undo the Belt buckle (18) by pressing the red button firmly.
4. The Buckle tongues (19) can now be attached to the indicated places on the
cover using the integrated loops.
5. Put your child in the car seat with their buttocks at the back.
6. Place the Shoulder belts (17) directly over your child's shoulders.
7. Place both Buckle tongues (19) together and lock them in place in the Belt
buckle (18). You should hear an audible "CLICK".
8. If you are using a seat with a SensorSafe Clip, push the clip closed until you
hear an audible "CLICK" and slide the closed clip down towards the Belt
buckle (18).
9. Tighten the Lap belts (20) and then pull on the Central adjustment belt (21)
to tighten the Shoulder belts (17) until they rest snug against your child's
body.
The harness should be fitted tight enough so that it is not possible to put a
��
fold in any of the straps.
10. When using the SensorSafe clip, position the clip directly below the
shoulder pads.
REMOVING AND REATTACHING THE SEAT COVER
The car seat cover consists of 4 parts. These are fastened to the car seat
at several places. Once unfastened, the individual parts of the cover can be
removed. To reattach the cover, follow the removal instructions in the reverse
order.
The cover may only be washed at 30°C with a delicate wash program
��
otherwise it may result in discolouration of the cover fabric. Please wash
the cover separately from other laundry and do not dry it in the dryer or in
direct sunlight!