Skoda 57A 092 160D Manual Del Usuario página 23

Please note:
The components (T to Z) are not included in the set and must be ordered separately from
the spare parts catalogue (ETKA) depending on the equipment specification.
- For vehicles with fixed rear seats
Switch (T)
Switch cover (U)
Support (V)
Adhesive (Z)
- For vehicles with Varioflex rear seats
Switch (W)
Switch cover (X)
Support (Y)
Adhesive (Z)
List of special tools
Corrosion protection filler spray – SprayMax 1K Acrylic Filler (Standox)
Wax preservative spray – Multi-Wax (Henkel)
General purpose cleaner (we recommend Terostat 8550)
Torque wrench
Cutter set
Clamps (for holding the adhered support in position while the adhesive is drying)
Important fitting information
Please note: The vehicle must be clean – the best way to do this is to
take it to a car wash.
Fitting procedure
The vehicle battery should be disconnected during fitting.
The individual components must be removed and refitted in accordance with the instructions
in the ŠKODA Repair Manual.
Place the vehicle on the arms of the workshop lifting platform.
The following components must be removed from vehicles that are set up to accommo-
date a tow bar:
- Rear bumper (and mud flaps if fitted),
- Bar; if required, the foam support under the bumper,
- Boot lid latch striker cover,
- Right-hand side panelling in the luggage compartment (when viewed in the direction of
travel).
The following components must be removed from vehicles that are not set up to accom-
modate a tow bar:
- Rear bumper (and mud flaps if fitted),
- Bar; if required, the foam support under the bumper,
- Boot lid latch striker cover,
x 1 order no. 3G0 959 511A WHS
x 1 order no. 5G0 868 345
x 1 order no. 575 868 784
x 1 order no. D 001 210 M2
x 1 Order no. 565 959 511
x 1 Order no. 565 868 345
x 1 Order no. 57A 867 428
x 1 order no. D 001 210 M2
EN
23