Adjustment Of Upper Blade Guide'S Height (Fig.11); Right-Angle Workbench Adjustment (Fig.12 And 13) - Fox F28-182A Manual De Instrucciones

The two support bearings (30) Fig.7 and (31) Fig.9 support the saw blade (26) Fig.1 only during cutting
operations. When the machine works in no-load condition, the saw blade mustn't touch the ball bearings.
Loosen hex head screw (40) Fig.9
d.
Move the part (49) Fig. 9 in order that the wheels (29) Fig.10 are about 1 mm behind teeth's base. Tighten
e.
firmly screw (40) Fig.9.
Loosen hex head screws (38) Fig.10.
f.
Push the two wheels (29) Fig.10 in the direction of the saw blade until they come in contact with the saw
g.
blade (saw blade musn't get stuck).
Tighten hex head screws (38) Fig.10.
h.
Make the upper wheel (7) Fig.1 rotate clockwise by hand in order to place the wheels correctly (they must
i.
touch lightly the saw blade).
After finishing adjustment operations, close the saw blade protection (34) Fig.9.
j.
WARNING:
AFTER CARRYING OUT ALL ADJUSTMENT OPERATIONS, TAKE CARE OF CLOSING
THE DOORS CORRECTLY AND LOCK THE FASTENERS. DURING USE, THE TWO
DOORS MUST BE CLOSED. IT IS FORBIDDEN TO USE THE MACHINE IF THE DOORS
ARE OPEN.

ADJUSTMENT OF UPPER BLADE GUIDE'S HEIGHT (Fig.11):

Upper blade guide's (11) Fig.1 height must be adjusted:
- after any cutting operation, in order that it is suitable for workpiece height (during cutting, upper blade
guide position must be about 3 mm over the workpiece);
- after saw blade or workbench adjustment (for example after saw blade replacing or tension operation, or
after workbench adjustment).
Loosen saw blade guide locking knob (20) Fig.2.
a.
Turn saw blade guide adjustment knob (19) Fig.2 and lower saw blade guide (11) Fig.1 the nearest to the
b.
workpiece, in order that there is a gap of about 2-3 mm between it and the workpiece.
Tighten saw blade guide locking knob (20) Fig.2.
c.
WARNING:
BEFORE ADJUSTING UPPER BLADE GUIDE, DISCONNECT THE MACHINE AND WAIT
FOR THE SAW BLADE TO STOP COMPLETELY.

RIGHT-ANGLE WORKBENCH ADJUSTMENT (Fig.12 and 13) :

Cut is perfectly perpendicular if workbench surface is perpendicular to the saw blade. To obtain this adjustment,
proceed as follows:
Raise upper blade guide (11) Fig.12.
a.
Loosen workbench angle locking lever (18) Fig.2.
b.
Place a square (not provided) between the saw blade (26) Fig.2 and the workbench (15) Fig.1.
c.
Angle the workbench (15) Fig.1 by turning the adjustment wheel (19) Fig.2 until it is placed at 90° with the
d.
saw blade.
Tighten workbench angle locking lever (18) Fig.2.
e.
After placing the workbench at right angle with the saw blade, loosen the nut (42) Fig.13, then adjust the
f.
hex head screw (41) Fig.13 until the head of the screw touches machine's support.
Tighten the nut (42) Fig.13 to fix the hex head screw (41) Fig.13.
g.
EN
30