Workbench Angle (Fig. 14A); Connection To A Dust Collection Device; Operation; On / Off Switch - Fox F28-182A Manual De Instrucciones

WORKBENCH ANGLE (Fig. 14A):

Workbench can be angled up to 45° to perform angle cuts. To tilt it, proceed as follows:
Loosen workbench angle locking lever (18) Fig.2.
Tilt the workbench according to the angle you need. To this aim, use the workbench angle indicator (16)
a.
Fig.2.
Then, tighten workbench locking lever (18) Fig.2.
b.
WARNING:
IF THE WORKBENCH IS TILTED, ENSURE THAT RIP FENCE IS ON THE RIGHT SIDE OF
THE SAW BLADE, SO AS TO PREVENT THE WORKPIECE FROM FALLING DOWN.

CONNECTION TO A DUST COLLECTION DEVICE

WARNING:
INHALATION OF DUST OF CERTAIN TYPES OF WOOD, AS FOR EXAMPLE OAK,
BEECH OR ASH-TREE CAN ENDANGER HUMAN HEALTH. WE RECOMMEND YOU TO
WORK OUTDOORS, TO USE AN EFFICIENT DUST COLLECTION DEVICE (AIR SPEED
MUST BE 20 M/S INSIDE ASPIRATION INLETS).
WARNING:
WORKING WITHOUT USING A DUST COLLECTION DEVICE IS POSSIBLE ONLY:
- OUTDOORS
- FOR WORKS INVOLVING A SHORT PERIOD OF TIME (UP TO 30 MINUTES)
- WEARING A DUST-MASK
IF YOU WORK WITHOUT USING A DUST COLLECTION DEVICE, DUST PILES UP AND
MUST PERIDICALLY REMOVED.
Connect the dust collection device to the dust collection outlet (6) Fig.2, and if necessary use a compatible
adapter.
WARNING:
CONNECT TO THE POWER SUPPLY AND START THE BANDSAW ONLY AFTER
CHECKING THAT THE MACHINE IS FASTENED, THAT THE WORKBENCH IS
ASSEMBLED AND ADJUSTED, THAT SAW BLADE TENSION IS CORRECT AND THAT
ALL SAFETY AND PROTECTION DEVICES ARE PERFECTLY EFFICIENT. OTHERWISE,
THE BANDSAW COULD START SUDDENLY AND CAUSE SERIOUS INJURIES.

ON / OFF SWITCH


Start = push the green button (g) Fig.14B.

Stop = push the red button (h) Fig.14B of the bandsaw.
In case of power failure, the tool is stopped by a "minimum voltage" relay inside the switch. This prevents the
machine from starting when the electric energy recovers. Press the green button to re-start the bandsaw.
EN

OPERATION

31