How To Make A Bag From A Roll - Excalibur EHVR12 Manual Del Usuario

SAFETY
For your safety, follow these precautions when using your Vacuum Sealer:
• Read Owner's Manual carefully before using the machine for the first time.
• Do not use the Vacuum Sealer on wet or hot surfaces, or near a heat source.
• Do not immerse machine or power cord in water or any other liquid.
• Plug Vacuum Sealer into grounded power sources only, do not use extension cord.
• To disconnect, unplug directly from power source. Do not disconnect by pulling on cord.
• Do not operate appliance with damaged power cord.
• Only use the Vacuum Sealer for its intended use.
• Only use Vacuum bags, accessories and attachments.
MAINTENANCE
• Unplug before cleaning.
• Clean appliance regularly with damp cloth and mild soap to remove crumbs, dust, debris.
• Chamber Seal Gasket is removable to clean any liquids that may have escaped from
Vacuum bag during process.
PREPARATIONS
• Read all manuals and instructions before starting.
• Plug in machine.

HOW TO MAKE A BAG FROM A ROLL

1. Open the lid and raise the cutter holder, pull out the roll bag to the needed length and put
down the holder, then cut the bag.
2. Simply cut the roll by slicing the cutter.
3. Put the open end of the roll across the seal wire (please make sure the open end is across
the seal wire).
4. Close the lid, press the lid by hand, and meanwhile press the locks at both ends of the
machine by fingers to lock the lid.
4. Press Seal button, machine enters into individual seal mode. Seal wire works. Digital display
number counts down from pre-set seal time to 0. Seal wire stops, pump works around 4
seconds. Machine releases and beeps, then finishes working. After that the machine will
be back to Ready-to-Work mode.
5. Take out the roll end and check the seal.
Note: A positive seal will look "clear" upon inspection. If the seal is spotty, incomplete,
wrinkle, white or milky, please cut the seal and restart the sealing process.
www.ExcaliburDIY.com
Professional Vacuum Sealer
5