Replacemente Of The Flame Control Fuse; Turning Off In Case Of; Malfunction - Unox ChefTop Gas Manual De Instrucciones

ChefTop™ - BakerTop™ ChefTop™
7.1 RESETTING OF THE SAFETY THERMOSTAT
The appliance is supplied with a safety thermostat with a
manual reset. This safety thermostat is needed to protect
the appliance from overheating. When activated, close
gas supply to the burner and the display panel shows the
message "EF4".
This safety device can be found on the bottom part of the
back panel of the oven: to reset the thermostat,remove
the black cover and push in the small central pin.
If the safety thermostat activates again, contact your near-
est UNOX service centre.
7.2 RE-SETTING OF THE LIGHTER DEVICE
In case the burner stops the display 1 shows "GAS"
message, the
it is necessary to push button and wait for the burner
to light again.
7.3 REPLACEMENTE OF THE FLAME CONTROL FUSE
In case the burner starting system does not work, it is
necessary to check the flame control fuse is not burnt. If
this is the case, the fuse must be replaced.
The flame control fuse is placed on the back of the oven,
below the round black cap indicated by "FUSE" plate.
ENGLISH ENGLISH
13 11
button flashes and the buzzer bleeps:
WARNING!! Disconnect the oven from the electric
supply before removing the fuse!
To replace the fuse proceed as follows:
• open the round black cap by pushing it and at the same
time turn it counter clockwise of around 20 degrees
• remove the cap of the fuse holder
• remove the fuse from the fuse holder cap
• replace the fuse with a new one with similar technical
characteristics (Fast 1,6A – 250V)
• place the fuse holder cap back
• close the round black cap by pushing it and at the same
time turn it clockwise of around 20 degrees
8. TURNING OFF IN CASE OF

MALFUNCTION

In case of malfunction it is necessary to disconnect the
appliance:
• switch off the electrical power supply isolator switch,
that is between the appliance and the network.
• close the gas cock
contact your nearest UNOX service centre.
•
ENGLISH