Unox ChefTop Gas Manual De Instrucciones página 21

2.4 POSITIONING
Place the appliance respecting the safety standards indi-
cated below.
Place the appliance so that its back can be easily reached
in order to make the electrical connections and to pro-
vide the necessary service.
Avoid to install the oven near heat sources.
The appliance is not suitable for built-in installation
or side by side positioning.
It is recommended to leave 10 cm cm of free room all
around the appliance.
With particular reference to the ovens, all models must
be placed upon a support, such as a prover, a stand or a table.
Never install the appliance on the floor.
If the appliance is placed near walls, partitions, kitchen
cabinets, decorated edges, etc., it is recommended these
are made of non combustible material.
Otherwise, they must be coated with non combustible
thermal insulating material and the fire prevention stand-
ards must be respected.
Do not install the appliance near a fryer. because some fat
may enter inside the oven and settle on the electric parts,
causing malfuncitoning of the equipment, or enter inside
the burner box and cause problems on the gas combustoin.
Avoid to install the appliance near inflammable substances
containers, eg.: gas cylinders.
Verify that the appliance is installed on a flat and
level surface.
In case, once the oven is placed, the door handle does not
properly close the door, it is necessary to accommodate
the handle latch, as described here below:
• open the door of the oven (pic.1), slightly unloose the
fixing screws of the door latch (pic.2)
• close the door and turn the handle to lock it (pic.3)
• if the door remained closed and the handle is perfectly
in vertical position, open the door and tightly fix the fixing
screws of the latch (pic.4).
• in case the problem is not solved, repeat the procedure
unloosing more the latch fixing screws.
WARNING! In case the oven is placed on a non per-
fectly flat surface, the handle does not properly close: if
the surface is only lightly deformed, it is possible to solve
the problem by following the latch accomodation proce-
dure described here above; this procedure can not be
used to solve the problem in case the surface shows big
deformations.
Install the appliance inside rooms where there is a sufficient air
change in order to avoid the formation of toxic substances.
Attention! Keep free the exhaust fumes chimney
placed on the top of the oven.
For the installation, the exhaust fumes conveying and the
minimum wall ventilation, refer to installation and safety na-
tional standards in force in the country where the oven is
UNO
R
ENGLISH ENGLISH
20 14