aquatermic inverter Manual Del Usuario página 11

Go to the FUNCTION page and locate "Cool+hot water", then, configure it through the Up/Down
key , "Cool" or "Hot water".
[Notes]
① "Hot water" will take precedence only when "Water tank" is available, other it will tell
"Reserved".
② This setting will be memorized upon power failure.
2.2.6 Heat + Hot water
This compound mode enables the user to give priority to the "Heat" or "Hot water" mode
depending on the actual demand.
[Operation Instructions]
Go to the FUNCTION page and locate Heat+hot water, then, configure it through the Up/Down
key , "Heat" or "Hot water".
[Notes]
① "Hot water" will take precedence only when "Water tank" is available, other it will tell
"Reserved".
② This setting will be memorized upon power failure.
2.2.7 Quiet
This function can be activated when the running noise is too high.
[Note]
when this function is activated, frequency of both the compressor and the fan will go down and
also the capacity of the unit will correspondingly decrease.
[Operation Instructions]
Go to the FUNCTION page and locate "Quiet", then, configure it through the Up/Down key
, "On" or "Off".
[Notes]
① It can be set to "On" or "Off" no matter if the unit is in operation or not.
② Once it is activated, it should be deactivated manually or by Quiet Timer.
③ This setting will be memorized upon power failure.
④ It will be deactivated when the unit is turned off.
2.2.8 Quiet Timer
When running noise is too high at some specific timer period, this function enables the unit run
quietly at this time period.
[Operation Instructions]
1. Go to the FUNCTION page and locate Quiet timer, then, access to the QUIET TIMER setting
page.
2. At the QUIET TIMER setting page, select "Start time" or "End time" through the Left/Right
keys and then configure the desired time through the Up/Down keys
3. When the mode setting is finished, then by pressing "Save", a pop-up window will pop up to
remind if you are determined to save this setting. If so, press the "OK" key
8
Operation Instructions
.
. If not, press the