aquatermic inverter Manual Del Usuario página 17

2. At the CLOCK TIMER setting page, by the Left/Right key
parameter and then by the Up/Down key
3. When this setting is concerned about time value, by pressing the Function key no. 1
alternately set the hour or minute values, and by pressing the Up/Down key
decrease the corresponding value which will be continuously changed by pressing and holding the
key. (Unless otherwise specified, all timer settings follow the similar way.)
4. When the setting is finished, save it by pressing the Function key no. 2
without being saved is ineffective.
5. When the setting has been saved, activate the "Clock Timer" at the FUNCTION page.
[Notes]
① When "Weekly timer" and "Clock timer" settings are performed at the same time, the latter
takes precedence.
② When the water tank is available, the allowed running modes include "Heat", "Cool", "Heat+
hot water", "Cool+hot water", and "Hot water".
③ When the water tank is unavailable, the allowed running modes only include "Heat" and
"Cool".
④ When "Clock timer" has already been set and the concerned modes include "Hot water",
if resetting "Water tank" from "With" to "Without", then "Hot water" mode will be automatically
changed to "Heat", "Cool+hot water"/ "Heat+hot water" changed to "Cool"/ "Heat".
2.2.14 Temp. Timer
This function will make the unit run with certain temperature in a certain period within a day
based on the user's actual demand.
[Operation Instructions]
1. At the homepage, by pressing the Function key
locate where "Temp timer" is, after that, press OK key
2 At the TEMP TIMER setting page, by the Left/Right key
and then by the Up/Down key
"Period 1", "WT-HEAT 1", "Period 2" and "WT-HEAT 2".
configure it.
access to the FUNCTION page, and then
to go to the TEMP TIMER setting page.
configure it. The configurable parameters include "Mode",
14
Operation Instructions
select the desired
increase or
, or this setting
select the desired parameter