Weekly Timer - aquatermic inverter Manual Del Usuario

Operation Instructions
⑤ When Sanitize is activated, "Disinfection" will show on the home page of the control until
this operation is finished. If this operation fails, "Disinfect fail" will show. In this case, by pressing any
key, "Disinfect fail" will be cleared or it will be always there.
⑥ When Sanitize is activated, it will quit upon "Communication error with the indoor unit" or
"Water tank heater error".

2.2.12 Weekly Timer

This function will make the unit run with certain modes in certain periods within a week based on
the user's actual demand.
[Operation Instructions]
1. At the homepage, by pressing the Function key
then locate where "Weekly timer" is by switching pages, after that, press OK key
WEEKLY TIMER setting page.
2. At the WEEKLY TIMER setting page, by the Right/Left key
desired week day and then by the Up/Down key
shown in the figure below. When this setting is finished, press OK key
page.
3. At the week day's setting page, it is allowed to set the running mode (Mode), temperature set
point (WT-HEAT), and water tank temperature (T-Water Tank). The running mode includes "Heat",
"Cool", "Hot water", "Heat+ hot water", "Cool+ hot water" (the last three ones are available only
when "Water tank" is set to "With". There are totally five periods for each day, and each period can be
set to "√"or "×". Besides, it is able to set the "Start time" and "End time" for each period, as shown in
the figure below.
access to the FUNCTION page, and
to set this day, "√", "×" or "Holiday", as
11
to go to the
it is able to select the
to go to this day's setting