View - aquatermic inverter Manual Del Usuario

Operation Instructions
Lower limit water-out
temperature at the
21
weather-dependent
mode for cooling
Temperature deviation
22
for cooling
Temperature deviation
23
for heating
Temperature deviation
24
for heating water
25 Room temp variation
26 Run time
Solar kit-start temp
27
variation
Solar battery-max.
28
temp

2.4 View

At the view pages, the user is enabled to view the unit's running state, running parameters,
errors, version of the wired controller etc.
[Operation Instructions]
At the homepage, by pressing the Function key no.3
shown in the figure below.
2.4.1 Status View
At the status view pages, the user is enabled to view the unit's running status, like compressor
On/Off, fan 1 On/Off, water pump On/Off, antifreeze On/Off, defrost On/Off etc.
[Operation Instructions]
1. At the VIEW page, select "Status" and then press the OK key
7~14°C[With FCU]
Lower WT-Cool
18~21°C[Without FCU]
ΔT-Cool 2~10°C
ΔT-Heat 2~10°C
ΔT-hot water 2~8°C
ΔT-Room temp 1~5°C
Run time 1~10min
T-Solar start 10~30°C
SL- battery Max 90~130°C
45~57°F[With FCU]
64~70°F[Without FCU]
36~50°F
36~50°F
36~46°F
36~41°F
/
/
50~86°F
194~266°F
, it is able to go to the VIEW page as
25
7°C/45°F[With FCU]
18°C/64°F[Without FCU]
5°C/41°F
10°C/50°F
5°C/41°F
2°C/36°F
3min[with FCU]
5min[witnout FCU]
15°C/59°F
110°C/230°F
to go to the STATUS page.