aquatermic inverter Manual Del Usuario página 18

Operation Instructions
3. When the setting is finished, save it by pressing the Function key no. 2
without being saved is ineffective.
4. When the setting has been saved, activate the "Temp. timer" at the FUNCTION page.
[Notes]
① When "Weekly timer", "Clock timer", and "Temp. timer" settings are performed at the same
time, the last one takes precedence.
② This function works only when the unit is in operation.
③ The allowed running modes include "Heat" and "Cool"
④ When the start time of "Period 2" is equal to that of "Period 1", then the set point of "Period 2"
takes precedence.
⑤ TEMP. TIMER is judged by the timer value.
⑥ During the setting, the temperature set point which is set manually always takes precedence.
2.2.15 Solar timer
When the solar system is prepared, this function will decide which period to let the solar system
to run. However, if the solar system will run virtually depends on the temperature difference between
the solar panel and the water tank.
[Operation Instructions]
1. Go to the FUNCTION page and locate "Solar timer", then press OK key
.
as shown below
No. Full Name
1 Solar kit start time
2 Solar kit stop time
2. At the "Solar Timer" page, locate "Start time" or "End time" through the up and down keys
and then adjust the start or stop time also through the up and down keys
3. After configuration, press "Save" and then a dialog box will pop up. In the dialog box, press "OK"
to confirm the configuration, or press "Cancel"
4. After saving the configuration, this page will automatically back to the FUNCTION page with
the cursor stayed at "Solar timer", and then through the up and down keys
to activate "Solar timer".
[Notes]
① Once "Solar timer" is activated,it cannot be deactivated through ON/OFF operation but be
Displayed Name
Start time
Stop time
15
Range
0:00~24:00
0:00~24:00
to cancel this configuration.
, or this setting
to go to the page
Default
8:00
18:00
.
to set it to be "ON"