Programming Inputs; Calibration Procedure Notes - Balluff BTL7-A/C/E/G5 Serie Manual Del Usuario

BTL7-A/C/E/G5_ _-M_ _ _ _-B/Z-DEX_-K_ _/KA_ _
Micropulse Transducer - Rod Style
6
Calibration procedure
Output Transducer
gradient
Rising BTL7-A...
BTL7-G...
BTL7-C...
BTL7-E...
Falling BTL7-A...
BTL7-G...
BTL7-C...
BTL7-E...
Tab. 6-1: Value table for teach-in and inverting
6.1

Programming inputs

Programming inputs La and Lb must be used in order to
make settings. A programming input at 10 to 30 V
corresponds to activation (high active).
The Balluff BTL7-A-CB02-K adjusting box can be used for
this (see Accessories on page 25).
Automatic deactivation!
If no signals are transmitted via the
programming inputs for approx. 10 min,
programming mode is automatically ended.
6.2

Calibration procedure notes

Prerequisites
– Programming inputs are connected.
– The transducer is connected to the system controller.
– Voltage or current values from the transducer can be
read (using a multimeter, the system control or the
adjusting box).
Fig. 6-1: Connecting the BTL7-A-CB02-K adjusting box
www.balluff.com
Unit Min. Null
value value
V −0.5 0
V −10.5 −10.0
mA 0 0
mA 3.6 4.0
V +10.5 +10.0
V +10.5 +10.0
mA 20.4 20.0
mA 20.4 20.0
Transducer
Indication Indication
for for teach-in
adjustment
2.0 4.0
2.0 4.0
6.0 12.0
6.0 12.0
2.0 4.0
2.0 4.0
6.0 12.0
6.0 12.0
Values for null and end point
– Any desired position of the magnet can be used as the
null or end point. However, the null and end points may
not be reversed.
– The absolute null and end points must lie within the
minimum or maximum range of what can be output
(see value table).
The last set values are always saved, regardless
of whether the setting was ended using the
programming inputs or automatically after
10 min have expired.
Value table for teach-in and inverting
The following examples refer to transducers
with 0 to 10 V or 4 to 20 mA output.
YE YE Calibration box
GY GY
8-pin
PK PK
RD RD
GN GN
BU BU
BN BN
WH WH
8-port luster terminal
Ignition protection "d"
Flameproof enclosure
End Max. Error
value value value
+10.0 +10.5 +10.5
+10.0 +10.5 +10.5
20.0 20.4 20.4
20.0 20.4 3.6
0 −0.5 −0.5
−10.0 −10.5 −10.5
0 0 20.4
4.0 3.6 3.6
Supply
6-pin
Adapter cable with
connector (luster
terminal)
english 15