Powering On/Off - Master & Dynamic MG20 Manual De Instrucciones

CONNECTIVITY
WIRED AUDIO
Plug the provided USB-C to 3.5mm cable into headphone audio input to engage
passive (wired) audio. Headphones are required to be powered on for audio
to work.
PAIRING / CONNECT TO A BLUETOOTH DEVICE
Activate Pairing Mode by powering ON the MG20 and continuing to hold the
button until the ring pulses and the pairing tone is heard. Access the
Bluetooth menu on your device and select M&D MG20.
MULTIPOINT
Up to two devices can be connected to the MG20 at one time, including the
Low-Latency Adapter. If two devices other than the Low-Latency Adapter are
connected to the MG20, the MG20 will need to be put back in pairing mode in
order to reconnect to the Low-Latency Adapter.
LOW-LATENCY ADAPTER
Plug the adapter into a PC or Playstation and power on the MG20. If no
connection is made:
1. Unplug the adapter.
2. Put the MG20 into pairing mode.
3. Ensure your PC or Playstation is powered ON.
4. Plug the adapter back in.

POWERING ON/OFF

Press and hold button to power ON/OFF. Battery level will be displayed at
startup. To conserve power, the MG20 will enter sleep mode after 10 minutes
of not being worn.
4