Spare Parts; Decommissioning; Dismantling - Wega MININOVA CLASSIC DUO Manual De Uso Y Mantenimiento

7.5.4 Perforated disk cleaning
Weekly perform the cleaning of the perforated disk
in the following way:
• Remove the seal (1) by
levering it with a screw-
driver, being careful not
to damage it;
ROSSO
C:0 M:100 Y:100 K:0
NERO
C:0 M:0 Y:0 K:100
• remove the perforated
VERDE
C:100 M:0 Y:100 K:0
disk (2) and wash it with
hot water;
• place the perforated disk
and seal back to the original position.
7.5.5 Cleaning the shower screen group and filter holder
Clean daily the shower screen group and of the filter
holder with the brush provided.
Thoroughly clean the inside of the coupling ring and
of the filter holder; as well as the edge and the wings
of the filter holder, so as to eliminate any accumulated
coffee residues.
Use the special toothbrush supplied (see spare parts catalog).
44 160
of
7.5.6 Cleaning of the steam spout
On a weekly basis, carry out the steam spout clean-
ing as follows:
• Immerse the spout in a jug with water and a specific
detergent according to manufacturer's instructions;
2
• heat the solution with the steam of the spout;
• let the spout cool off keeping it
immersed in the solution for at
least 5 minutes to allow the de-
1
tergent to rise inside the spout by
cooling effect;
• repeat the operation 2 or 3 times
until milk is delivered.
8.

SPARE PARTS

Machine components and/or parts must be replaced
only by the Maintenance Technician.
The User must not replace the components and/or parts of the
machine.
9.

DECOMMISSIONING

The machine must be decommissioned by the Main-
tenance Technician, because the equipment must be
disconnected from the electricity and water mains, and
all the internal circuits must be emptied of the water.
The commissioning of the machine after this period
must be performed only by the Maintenance Technician.
The User must not perform decommissioning after long time and/
or commissioning of the machine.
10.

DISMANTLING

The dismantling of the machine must be performed
by the Maintenance Technician.
USER manual