Tensioning The Ribbed V-Belt - Stihl Cutquik TS 410 Manual De Instrucciones

2
2
2
3
1
3
3
: Fit the starter cover (1) over the
studs (2)
: Tighten up the nuts (3) by hand
1
2
: Push the V-belt guard (1) into place
: Screw in the bolt (2) and tighten it
up
TS 410, TS 420
1
2
1
: Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment
: Note the connector position
: Insert the square nut into the guide
in the connector and hold it in place
: Fit the water attachment to the
adjusting lever with the longer banjo
bolt – screw in the banjo bolt by
hand
: Align the guard
: Insert the water hose into the guide
in the V-belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
: Tighten up the banjo bolt
Continue as described in the chapter
"Tensioning the V-belt"
English / USA

Tensioning the ribbed V-belt

This machine is equipped with an
automatic spring-action V-belt
tensioning device.
Slackening the V-belt
2
1
1
1
: Undo the nuts (1)
: Turn the tensioning nut (2)
anticlockwise with the combination
wrench – approx. 1/4 turn, until it
reaches "0"
If the cast arm and guard are
mounted on the outboard side, the
ribbed V-belt is already slackened.
0
27