Setting The Carburetor - Stihl Cutquik TS 410 Manual De Instrucciones

Setting the carburetor

Basic information
The ignition system of this cut-off
machine is equipped with an electronic
maximum speed limiter. The maximum
speed cannot be increased beyond a
specified limit.
The carburetor comes from the factory
with a standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
The high speed adjusting screw on this
carburetor can only be set within narrow
limits.
If the setting is too lean, there is a
risk of a shortage of lubricant and
overheating – resulting in damage
to the engine.
TS 410, TS 420
Standard setting
: Switch off engine
: Only replace the air filter if the
engine is noticeably down on power
: Check the spark arresting screen* in
the muffler and clean or replace it if
necessary
: Carefully turn the high speed
adjusting screw (H) anticlockwise
as far as possible – rich setting stop
: Carefully turn the low speed
adjusting screw (L) clockwise as far
as possible, then open it 1 turn
* According to equipment version
English / USA
Setting the idle speed
Engine stops when idling
Set to standard setting.
: Turn the idle speed adjusting
screw (LA) clockwise until the
abrasive wheel begins to turn, then
turn it back 1 turn
Abrasive wheel runs when idling
Set to standard setting.
: Turn the idle speed adjusting
screw (LA) anticlockwise until the
abrasive wheel stops running,
then turn it another 1 turn in the
same direction
37