Starting / Stopping The Engine - Stihl Cutquik TS 410 Manual De Instrucciones

Starting / stopping the
engine
3
3
2
: Press the throttle trigger
interlock (1) and throttle trigger (2)
at the same time
: Hold both triggers down
: Move the slide control (3) to START
and hold it in position too
: Release the throttle trigger, slide
control and throttle trigger interlock
in succession – starting throttle
position
TS 410, TS 420
1
: Set the choke (1) according to the
engine temperature
1
T Engine cold
Engine warm;
Engine has already run, but has
e not warmed up;
If the hot engine has been
switched off for less than
5 minutes
Engine hot;
o If the hot engine has been switch
off for more than 5 minutes
English / USA
1
: Press the button (1) of the
decompression valve. This button
must be pressed again before each
fresh attempt to start the engine
: Press the fuel pump bulb (2) 7 – 10
times, even when the bulb is filled
with fuel
2
33