Abrasive Wheels - Stihl Cutquik TS 410 Manual De Instrucciones

English / USA
Tensioning the V-belt
1
1
1
: Fit the combination wrench over the
tensioning nut
The tensioning nut is spring-loaded
– hold the combination wrench
securely.
: Turn the tensioning nut clockwise
approx. 1/8 turn – the tensioning nut
will be engaged by the spring
: Continue turning approx. 1/8 turn,
up to the stop
Do not turn the combination wrench
further by force!
The ribbed V-belt is automatically
tensioned by the force of the spring in
this position.
: Remove the combination wrench
from the tensioning nut
: Tighten up the nuts (1)
28
Retensioning the ribbed V-belt
1
1
1
The V-belt is retensioned without the aid
of the tensioning nut.
: Undo the nuts (1)
: The V-belt is automatically
tensioned by the force of the spring
: Tighten up the nuts (1) again

Abrasive wheels

The abrasive wheels are subjected to
extremely high loads, especially when
cutting free-hand.
The abrasive wheels developed by
STIHL in cooperation with leading wheel
manufacturers are of very high quality
and precisely matched to the application
in question, as well as to the engine
power of the respective cut-off
machines.
They are of consistently outstanding
quality, with high axial and radial runout.
Transport and storage
– The abrasive wheels must not be
exposed to direct sunlight or other
sources of heat during transport and
storage
– Avoid knocks and bumps
– Spare abrasive wheels must be
stored in a dry place at constant
temperature, stacked one on top of
the other on a flat surface, in their
original packaging.
– Abrasive wheels must not be stored
near corrosive liquids
– Composite abrasive wheels must
be protected against frost
TS 410, TS 420