Stihl Cutquik TS 410 Manual De Instrucciones página 35

English / USA
: Place the cut-off machine carefully
on the ground, ensuring that the
abrasive wheel cannot touch any
objects or the ground. There must
not be anyone within the swivel
range of the cut-off machine.
: Make sure you have a firm footing
: Press the cut-off machine firmly
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
: Place your right foot on the shroud
34
: With your right hand, slowly pull out
the starter handle as far as the stop,
then pull it through quickly and
strongly. Do not pull the rope out
completely
Do not let the starter grip snap back
– it may break!
Guide it back into the housing in the
opposite direction so that it can
rewind properly
When the engine has turned over for
the first time
1
: Set choke lever (1) to o .
Press the button of the
decompression valve again and
continue cranking.
When engine is running
: Squeeze throttle trigger fully and let
engine run at full throttle for approx.
30 seconds
: When it has warmed up, set the
choke lever to e
1
: The slide control (1) moves to the
normal position # when the throttle
trigger is squeezed
If the carburetor has been set correctly,
the abrasive wheel should not rotate
when the engine is idling.
The cut-off machine is now ready for
use.
TS 410, TS 420