STANDARD OR ANGLE MOUNTING INSTRUCTIONS
3. Slide the downrod (A) into the yoke of the motor
assembly (E), align the holes, then re-install the
downrod clip (DD) and downrod pin (EE). Secure
with downrod set screws (FF).
Hardware Used
DD
Downrod Clip
EE
Downrod Pin
Downrod Set
FF
Screw
4. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner: Take
the lead wires and make sure you have pulled them
all the way through the top of the downrod. Measure
8 inches of lead wire, then cut the excess wire off
with wire cutters (not included).
3
DD
x 1
x 1
x 2
4
10
A
EE
FF
Lowes.com/harborbreeze
E