Kichler Maeve Manual De Instrucciones página 8

HANGING THE FAN (continued)
Step 4. Carefully feed fan wires and safety cable up through the downrod.
Thread the downrod onto the motor coupling until the clevis pin holes are
aligned. Next, replace the clevis pin and hairpin, then tighten both set screws.
(Fig. 8)
Step 5. Slip the coupling cover, canopy hole cover and canopy onto the
downrod. Carefully reinstall the hanger ball onto the downrod. Make sure the
cross pin is in the correct position and the set screw is tight and the wires are
not twisted. (Fig. 9)
Step 6. Now lift the motor body into position and place the hanger ball into
the mounting bracket. Rotate until the "Check Tab" has dropped into the
"Registration Slot" and seats firmly. (Fig. 10) The entire motor body should
not rotate if this is done correctly.
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling
fan during operation.
8 | KICHLER.COM
Hairpin
Set Screw
Hairpin
Set Screw
Fig. 8
Hanger Ball
Cross Pin
Set Screw
Canopy
Canopy
Hole Cover
Coupling Cover
Fig. 9
Mounting Bracket
Registration
Slot
Check Tab
Fig. 10
Clevis Pin
Clevis Pin
Hanger Ball