Installing The Light Kit And Glass - Kichler Maeve Manual De Instrucciones

INSTALLING THE LIGHT KIT AND GLASS

NOTE: Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the circuit fuse. Turning the power
off using a wall switch is not sufficient to prevent electrical stock.
Step 1. Hold the light kit close to the switch housing and connect the WHITE
wires from the light kit and fan by pushing the connectors together. Follow the
Switch
Housing
same procedure with the BLACK wires. (Fig. 20)
Step 2. Tuck the connections neatly into the light kit. Remove one of three Light Kit
screws pre-installed on the switch housing and keep for later use. Loosen the
Screw
other 2 screws (do not remove). Place the two slot holes on the light kit over
Fig. 20
the 2 screws previously loosened from the switch housing. Rotate the light kit
until it locks in place at the narrow end of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed. (Fig. 20)
Step 3. Secure the glass to switch housing by twisting in a clockwise direction,
twist the glass gradually until it snaps on to the switch housing. Do not over-
tighten. (Fig. 21)
Glass
Fig. 21
14 | KICHLER.COM