Foreword; Set-Up; Placement; Electrical Connection - Enraf Nonius EN-Cardio Serie Instrucciones De Manejo

1 Foreword

Thank you for purchasing the Bike Reha. This ergometer will bring great flexibility to your cardiovascular
training routines.
The packaging contains 1) the Bike Reha, 2) these Operating Instructions.
In general, six of our products can be used for cardiovascular training. In addition to the Bike Reha (fig. 1,
page 30), these include the Step, the Stair, the Crosswalker, the Cruiser and the En-Mill treadmill.
When designing this ergometer a great deal of work went into ensuring that it was reliable, safe, user-
friendly and durable. To ensure that you use your Bike Reha properly and safely it is important that you
read through the following instructions before you start using it.

2 Set-up

2.1

Placement

If the floor is uneven then the height of the two rubber feet on the crossbars can be adjusted to
compensate. These feet can easily be rotated and fixed into position using suitable tools.
2.2

Electrical connection

To supply power to the electronics a protective earthing 230V socket is required. The device is
thermostatically protected to prevent overheating.
The maximum power consumption is approximately 40VA.
2.3

Initial use

After placing the Bike Reha in position you must wait for several hours before you can use it for the first
time! This is necessary because of possible condensation caused by large differences between internal
and external temperatures.
The connection for the power cord will be found on the left-hand side of the rear of the frame (see fig. 1,
page 30) After the power cord has been connected, move the switch to position 1. The Bike Reha is now
ready for use. To further operate the device, use the membrane keyboard. The various operations to be
performed on the keyboard are explained in these Instructions.
2.4

Environmental information

During the use of the Bike Reha no emissions appear that are outside the permissable range and that will
cause any environmental burden.
Your Bike Reha contains no materials that are noxious for the environment. As thus, at the end of the
duration of life, no special concern is needed. However, specialised companies can take apart the Bike
Reha and sort out the materials for recycling. By doing so you contribute to a better environment.
Please ensure that you are well informed of the local rules and regulations regarding to the removal of
equipment and accessories.
29