Seat Adjustment - Cub Cadet Volunteer Manual Del Operador

4x4 Switch (All 4x4 Models Only)
The 4x4 switch is located on the right side of the dash panel. Push
in top/bottom of switch to activate or deactivate 4x4 capability.
12V Power Outlet
The 12V power outlet is located in the center of the dash panel.
It is used for the convenience of plugging in accessories that
require a power source with a maximum load of 5A at 12V.
Cup Holders (If Equipped)
The cup holders are located between the seats. They are
designed for the use of non-alcoholic beverages.
WARNING:
Never operate this UV while under the
influence of alcohol or drugs. Doing so can result in
serious personal injury or death.
Seats
The driver seat has a tool box underneath it, which can be easily
accessed by lifting the seat. This box may be removed by turning
the two 1/4-turn fasteners securing it to the frame for easy access
to battery, etc.

Seat Adjustment

The seats can be adjusted by removing the bolts securing them
to the seat pan. Move the seat to the desired holes in the seat
pan, and reattach the seat using the bolts removed earlier. See
Figure 3-3.
Figure 3-3
Seat Belts
The seat belts are located on the outside of the driver and
passenger seats. When used together with the OPS (Rollover
Protective Structure) they are effective in reducing injuries to the
operator and passenger in the event of an accidental rollover.
Seat belt latches are located on the inside of the driver and
passenger seats.
WARNING:
Always wear the seat belt when
operating the UV.
The position of the lap belt portion of the seat belt should be
adjusted for both the operator and the passenger before driving.
Although having the belt at 300 is typical for many people, it will
not accommodate all body sizes and shapes. Make sure the seat
belt is adjusted to the lowest possible lap position before driving.
To adjust the position of the seat belts:
1. Loosen the seat belt mounting bolts.
2. Reposition both the buckle and retractor.
3. Tighten the mounting bolts.
Seat Belt Warning Indicator
The seat belt warning indicator will flash for 10 seconds once
the key is turned to the ON position to remind the operator and
passenger to fasten seat belt.
Cargo Box Electric Lift Switch (If Equipped)
The cargo box electric lift switch is located on the dash panel. It
activates lift to raise and lower cargo box.
Auxiliary Light Switch (Limited Edition Only)
The auxiliary light switch is located on the left side of the dash
panel. It turns power ON and OFF for the fog lights and light bar.
NOTE: If you are running the fog lights in addition to all the other
lights included with the Limited Edition UV, i.e., headlights, light
bar, more than 50% of the time, we recommend you purchase
the Heavy Duty Alternator Kit to prevent excessive drain of the
battery.
Rear Power Outlet Switch (If Equipped)
The rear power outlet switch is located on the left side of the
dash panel. It turns power ON and OFF for the rear outlet.
Cargo Box
The cargo box is raised by a gas spring. Manually remove the
contents of the cargo box before lifting the cargo box. Pull up on
the release latch located behind the driver's seat and lift up the
cargo box. Once the cargo box is in the raised position, access to
the engine is possible. If equipped with a electrical lift, the cargo
box can be raised to dump cargo.
IMPORTANT: Do not exceed the UV's Total Load Capacity of
1,400 lb, which includes driver, passenger, accessories, and cargo.
Do not exceed 1000 lb in the cargo box.
Half Doors (If Equipped)
The doors are designed to assist in keeping the operator and
passenger inside the UV during operation. Do not operate UV
without doors in place.
To open the half doors on the UV, pull the handle outward to
release the latch. To close, gently, but firmly, close door.
S
ection
3 — c F
ontrolS and eatureS
11