Cub Cadet Volunteer Manual Del Operador página 21

Ball Joints
Inspect the upper and lower front A-arm ball joints on each side
of the UV and the two tie rod ends for wear every 100 hours or
once a year. See Figure 5-9. If excessive wear appears, have ball
joints or tie rod ends replaced by your local Cub Cadet dealer.
Ball Joints
Figure 5-9
Rear Knuckles
Lubricate two grease fittings on each axle with two or three
shots of grease every 50 hours or after each use if consistently
running UV in water deeper than axle. See Figure 5-10.
Figure 5-10
Draining CVT Cover
Drain CVT cover every 50 hours or after driving UV through more
than 12" of water.
1. Remove CVT cover drain plug. See Figure 5-11.
2. Allow water to completely drain out.
3. Reinstall drain plug, and tighten securely.
Cleaning
The body panels are scratch and impact resistant automotive
quality ABS plastic. The use of standard car wash soap and
non-abrasive car wax is acceptable for cleaning the body panels.
Avoid any abrasive cleaner or rubbing compounds for these will
damage the body panels. Dry thoroughly to avoid water spots.
WARNING:
Damage may occur if direct hose spray comes in
contact with intake openings, or any other electrical
components, i.e. at instrument cluster or under dash.
Lube
Figure 5-11
DO NOT use a pressure washer.
S 5 — M & a
ection aintenance
21
djuStMentS