Drive Belt - Cub Cadet Volunteer Manual Del Operador

Wheels
WARNING:
Using an unstable lifting device and
UV support may result in bodily injury. Use a safe
lifting device and supports to work on raised UV.
1. Stop the UV on a level surface and apply parking brake.
2. Turn the ignition key to the STOP position and remove the
key.
3. Loosen but do not remove the five lug nuts from the axle
hub. See Figure 6-3.
Figure 6-3
4. Raise rear/front of UV with a safe lifting device and place
support stands under UV frame.
WARNING:
When lifting the rear of the UV for any
reason, DO NOT engage the rear wheels. Even if the
4x4 switch is in the OFF position, there is a possibility
that the front wheels may engage if the rear wheels
are spinning fast enough.
5. Remove the five lug nuts and the wheel. Place new wheel
on the axle hub and secure with nuts.
6. Tighten nuts diagonally until snug.
7. Remove support stands and lower UV.
8. Finish tightening the nuts to 65-75 ft-lb using a torque
wrench.
Changing Brake Pads
WARNING:
Using an unstable lifting device and
UV support may result in bodily injury. Use a safe
lifting device and supports to work on raised UV.
To gain access to the brake pads, remove the wheel as described
in the Wheels section. If less than .030" of material remains on the
pad, replace.
NOTE: Brake pads must be replaced as a set, i.e., right rear and
left rear.
To change the brake pads, follow the steps below and refer to
Figure 6-4.
1. Remove mounting bolts securing caliper and brake pads to
brake disc.
2. Remove brake caliper assembly from brake disc.
3. Clean lube slide pins.
4. Remove brake pads from caliper and replace with new
pads.
5. Press in brake piston and place caliper and new brake pads
into place, making sure brake disc is between the two
brake pads.
IMPORTANT: When pressing in brake piston, ensure not to
damage rubber piston seal.
6. Secure caliper and brake pads with mounting bolts
removed in step 1. Torque the mounting bolts to 22 to 26
ft-lb.
7. Replace wheel as described in Wheels section.
1
2
Figure 6-4

Drive Belt

IMPORTANT: See your Cub Cadet Dealer to have your belts
replaced.
3
4
S 6 — S 25
ection ervice