Technical Parameters - GRAPHITE 58G486 Instrucciones De Uso

● When cleaning never use petrol, solvents or detergents that could damage plastic parts of the saw.
● In case of excessive sparking on the motor commutator stop using the power tool and deliver it to
service workshop.
● During normal operation cutting blade gets blunt after some time. When it happens it is necessary to
apply greater pressure when moving the saw during cutting. When cutting blade is found damaged,
replace it immediately.
● Cutting blade must always be sharp.
CUTTING BLADE REPLACEMENT
● Use supplied hexagonal key to unscrew the bolt (8) for blade fixing by turning it counter-clockwise.
● To prevent rotation of saw spindle, lock the spindle with spindle lock button (10) when unscrewing the
bolt that fixes the cutting blade (fig. D).
● Disassemble outer collar washer (7).
● Use lower guard lever (3) to move lower guard (9) so it is hidden in the upper guard (2) maximally (check
condition and operation of the spring that pulls the lower guard at that time).
● Slide the blade out through slit in the saw base (5).
● Position new cutting blade so blade teeth and arrow on the blade match direction of the arrow on the
lower guard.
● Insert new cutting blade through the slit in the saw base and install it on the spindle by following
dismantle procedure in reverse order.
When installing cutting blade observe correct direction of the teeth. Arrow on the saw body shows
direction of spindle rotation.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace
both brushes at a time.
● Unscrew brush covers (16) (fig. E).
● Remove used brushes.
● Remove any carbon dust with compressed air.
● Insert new carbon brushes (fig. F) (brushes should easily move into brush-holders).
● Install brush covers (16).
After the brushes are replaced start the power tool with no load and wait until the brushes fit to the
motor commutator. Entrust replacement of carbon brushes only to a qualified person. Only original
parts should be used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Current frequency
Rated power
Spindle rotational speed with no load
Bevel range
Outer diameter of cutting blade
Hole diameter of cutting blade
Maximum thickness of cut wood Right angle
Protection class
Weight
Year of production

TECHNICAL PARAMETERS

Circular Saw
Bevel (45 )
0
20
Value
230 V AC
50 Hz
1200 W
5000 rpm
0 - 45°
0
185 mm
20 mm
65 mm
43 mm
II
3.8 kg
2020