Next Level Racing GT ELITE Manual De Instrucciones página 11

support@nextlevelracing.com
OVER-HANGING SEAT BRACKET
( )
FOR TALLER USERS
26c Align the first rear slot on the Seat Brackets with the T-Nuts previously installed in STEP 22. Bolt
through and secure with 4 x M8 Bolts and Washers.
27 Align the holes on the Butt-kicker pole with the T-Nuts previously installed in STEP 22. Bolt through
and secure with 2 x M8 Bolts.
SHIFTER INSTALLATION
Note: Install T-Nuts on the
Left Vertical Extrusions for a
Left Side Shifter setup.
28
Install 4 x T-Nuts into the outer channel of the Left or Right Vertical extrusion.
PARTS:
Repeat
on Other
• • 4 x M8 16mm Bolts
Side
• • 4 x M8 Washers
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 4 x T-Nuts
20
29 Align the slots on the Bottom Shifter Arm Bracket with the T-nuts previously installed in step 28. Bolt
through and secure with 2x M8 Bolts and Washers.
30 Align the slots on the Upper Shifter Mounting Corner Bracket with the T-nuts previously installed in
step 28. Bolt through and secure with 2x M8 Bolts and Washers.
INSIDE VIEW
OUTSIDE VIEW
31a
Install 4 x T-Nuts into the top and bottom side channels of the Shifter Arm.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1 x Shifter Mounting Corner
Brackets
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 1 x Shifter Mounting Corner
Brackets
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 1 x Shifter Arm
• • 4 x T-Nuts
21