Next Level Racing GT ELITE Manual De Instrucciones página 6

support@nextlevelracing.com
LEFT
REAR
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of right base
(Red dots are T-Nut placement)
Note: Slide 2 x
T-Nuts to rear for
seat sliders
BACK
01b
Slide 8 x T-Nuts into the outside channel of the right rear member.
FRONT
RIGHT
Note: For easier installation hand
screw M8 bolt in to T-nut to assist
sliding T-Nut in to channel.
Note: Slide 4 x T-Nuts
Note: Slide 2 x
to middle for wheel T-Nuts to front for
post
pedal support
FRONT
10 10
REAR
02 Align the threaded holes on the front and rear base extrusions with the pre-drilled holes on the right
base extrusion. Bolt through and secure with M8 Bolts and Washers.
Note: Depress locater tab on back
side of clip to install into channel.
03
Suggested 1 x Cable Management Clip installation into the top channel of the Rear Base member.
LEFT
REAR
04 Align the threaded holes on the front and rear base extrusions with the pre-drilled holes on the left
base extrusion. Bolt through and secure with M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
FRONT
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
RIGHT
PARTS:
• • Cable Management Clips
PARTS:
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
RIGHT
11 11