Important - Next Level Racing GT ELITE Manual De Instrucciones

support@nextlevelracing.com
ALUMINIUM EXTRUSION TIPS
• Please do not use power tools for assembly as over tightening can damage your frame
• Please ensure T-Nuts are correctly placed within the extrusion
• Lay out and build the cockpit on a level surface
• Do not force parts together
• Avoid cross threading bolts
• If in doubt consult the installation video or contact us at support@nextlevelracing.com
• The GT Elite is a two person build with the complete cockpit a two person move
• Beware of sharp edges on the extrusion pieces
ANGLE
Install cable clips at the location you
would like them during the build.
Leaving the installation of cable clips to
the end can present installation issues.
Depress the alignment tab at the back
during installation.
HEIGHT DISTANCE
8 8
LEFT
REAR
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of left base
(Red dots are T-Nut placement)
Note: Slide 4 x T-Nuts
Note: Slide 2 x
T-Nuts to front for to middle for wheel
post
pedal support
FRONT
01a
Slide 8 x T-Nuts into the outside channels of the left base member.
Video Instruction: bit.ly/nlrbuild
FRONT
RIGHT
Note: Slide 2 x
T-Nuts to rear for
seat sliders
BACK
9 9