Next Level Racing GT ELITE Manual De Instrucciones página 8

support@nextlevelracing.com
13
Install 2 x T-nuts into the inside channels of both Vertical Posts (Red Dots show placement).
)
A
Felt Pads
Note: Use level provided. Wheel plate
must be kept flat and level during installation
to avoid skewing.
14a
A) Remove protective layer on the Sticky Felt strips and stick them on to the Wheel Plate to prevent scratching when adjusting.
B) Align the Wheel Plate with the T-nuts previously installed in STEP 13. Bolt through and secure with M8 Bolts and Washers.
ADJUSTMENT RANGE
Loosen bolts securing the Vertical Posts to the base. Adjust to your desired position and tighten bolts lock in place. Loosen the
14b
bolts securing the Wheel Plate. Adjust to your desired height and angle using the alignment lines as a guide, tighten the bolts to
lock the Wheel Plate in place.
PARTS:
• • 4 x M8 T-Nuts
PARTS:
)
B
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Sticky Felt Pads (90mm x 10mm)
PARTS:
• • NIL
14
SIDE VIEW
( )
PRE-DRILLED HOLE
( )
LEFT
( )
PRE-DRILLED HOLE
( )
RIGHT
Note: For Shorter Users Please Skip
to STEP 16a & 16b.
15a Install 3 x T-Nuts into the top channel and 1 x T-Nut into the side channel of the left Pedal Arm. Repeat
the same steps for the right Pedal Arm.
15b
Align the Pedal Arm with the hole on the Upright Connection Plate. Bolt through and secure with M8
Bolt, Washer, Square Washer and Flange Nut. Repeat on the other side.
ALTERNATE PEDAL INSTALLATION
( )
FOR SHORTER USERS
(
PRE-DRILLED HOLE
( PRE-DRILLED HOLE )
( )
RIGHT
16a
Install 1 x T-Nut into the side channel of the Pedal Arm. Repeat for the other side.
Video Instruction: bit.ly/nlrbuild
PARTS:
TOP VIEW
• • 8 x M8 T-Nuts
PARTS:
• • 2 x M8 60mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
• • 2 x Square Washers
PARTS:
• • 2 x T-Nuts
)
( )
LEFT
15