Beem ESPRESSO-SELECT Manual De Instrucciones página 31

31
• Empty and clean the sieve insert after each use.
• Regularly clean and descale the device (see the "Cleaning and Care" chapter – "Descaling").
A dirty and / or furred-up device compromises the fl avour.
Preparation
PLEASE NOTE!
• Do not operate the device without water or with less water than is required to reach
the MIN marking.
• Never use the device without a suitable cup below the portafi lter.
Preheating
1. Fill the water tank (h) (see the "Handling and Operation" chapter – "Filling the Water Tank").
2. Make sure that the steam power control is in the
3. Switch on the device by pressing the
up and the control lamp
control lamp
4. Place the sieve insert you want (b / c) into the portafi lter (d) (see the "Handling and Oper-
ation" chapter – "Inserting / Removing the Sieve Insert").
5. Insert the portafi lter into the device (see the "Handling and Operation" chapter – "Inserting
the Portafi lter into the Device").
6. Place a suitable cup on the storage plate (f) under the portafi lter.
7. Press the button
8. When roughly one to two cups have run through, press the button
water. The pipes and the portafi lter are now also preheated.
9. Remove the sieve insert carefully.
10. Pour away the water from the cup.
Preparing Espresso or Coffee
1. Fill the water tank (h) (see the "Handling and Operation" chapter – "Filling the Water Tank").
2. Make sure that the steam power control is in the
3. Switch on the device by pressing the button
and the control lamp
05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 31 05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 31
button (11). The operating lamp
fl ashes. The device starts the heating process. As soon as the
is constantly lit, the device is preheated
(2). The device starts to pump water out of the water tank.
fl ashes. The device starts the heating process.
(Off) position.
again to stop the
(Off) position.
(11). The operating lamp
EN
(10) lights
(10) lights up
29.01.2021 14:40:41 29.01.2021 14:40:41