Heating Beverages With Steam - Beem ESPRESSO-SELECT Manual De Instrucciones

33
10. First hold the steam nozzle just below the surface of the milk to warm it up. Once the milk
is warm to the touch, hold the steam nozzle at the bottom of the frothing container so that
the milk is swirled around.
11. Once the milk froth is of the desired consistency, turn the selector switch to the
and pull the frothing container down and outwards.
12. Tap the frothing container one to two times on a solid surface to compress the milk froth.
13. Pour the milk froth into the drinking vessel or scoop it with a spoon.
14. Clean the steam nozzle after each use to prevent a blockage (see the "Cleaning and Care"
chapter – "Cleaning the Steam Nozzle").
Empty the drip tray after preparation so that it cannot overfl ow if you prepare another
drink.
15. If you no longer wish to use the device, press the
The device switches off and the operating lamp goes out.
If the device is not switched off manually, it automatically switches off after 25 minutes in
stand-by mode.

Heating Beverages with Steam

The steam that is produced by the device can be used to heat milk, beverages and water for
tea.
1. Take the milk frother nozzle (5) off the steam nozzle (6).
2. Follow steps 1. – 6. in the "Preparing Milk Froth" section.
3. Immerse the steam nozzle fully in the vessel containing the beverage that is to be heated.
4. Start the steam process as soon as the control lamp
the steam power control (3) to the
vessel.
5. Move the vessel in a circular motion to achieve faster heating.
6. Once the beverage has reached the temperature you want, turn the steam power control
to the position and pull the vessel down and outwards.
7. Clean the steam nozzle after each use to prevent a blockage (see the "Cleaning and Care"
chapter – "Cleaning the Steam Nozzle").
Empty the drip tray after preparation so that it cannot overfl ow if you prepare another
drink.
8. If you no longer wish to use the device, press the
The device switches off and the operating lamp goes out.
If the device is not switched off manually, it automatically switches off after 25 minutes in
stand-by mode.
05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 33 05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 33
button for approx. 3 seconds.
is constantly lit by gradually turning
position. The hot steam heats the liquid in the
button (11) for approx. 3 seconds.
EN
position
29.01.2021 14:40:48 29.01.2021 14:40:48