Cleaning The Steam Nozzle - Beem ESPRESSO-SELECT Manual De Instrucciones

EN

Cleaning the Steam Nozzle

To prevent any blockage, the steam nozzle (6) must be cleaned after each use.
1. Pull the milk frother nozzle
with mild detergent and warm water.
2. Turn the steam nozzle over the drip tray (e).
3. Switch on the device by pressing the button
and the control lamp
Please Note! The device must remain in brewing mode for cleaning. Do NOT activate steam
mode!
4. Turn the steam power control (3) to the
5. Press the button (2) to rinse milk and beverage residues out of the steam nozzle.
6. Wipe down the steam nozzle with a damp cloth.
If the steam nozzle has become clogged, you can release the blockage with a needle.
Descaling
Limescale deposits have an adverse effect not only on the quality of the coffee and the water,
but they also cause power losses and shorten the lifespan of the device. The thicker a limescale
layer is, the more diffi cult it is to remove.
We therefore recommend regularly removing limescale deposits with a descaling agent in
accordance with the water quality in your area and how often the device is used (approx. every
2 – 6 weeks).
The fi rst indications that descaling is required are a large amount of steam being produced and
slower brewing of the coffee.
For descaling we recommend the BEEM Premium Descaler Concentrate. The effi cient, food-
safe and environmentally friendly BEEM Premium Descaler Concentrate is available from selected
specialist stockists, via our website www.beem.de or from our customer service department on
request.
Descaling with the BEEM Premium Descaler Concentrate
1. Fill the water tank (h) up to the MAX marking with a concentrate / water solution of no
more than 1:20 (one part concentrate to 20 parts water).
2. Switch on the device by pressing the button
and the control lamp
3. Insert the portafi lter (d) into the device (see the "Handling and Operation" chapter –
"Inserting the Portafi lter into the Device").
4. Place a suitable vessel under the portafi lter.
05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 36 05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 36
(5) of the steam nozzle gradually down and off and clean the nozzle
(11). The operating lamp
fl ashes. The device starts the heating process.
position.
(11). The operating lamp
fl ashes. The device starts the heating process.
36
(10) lights up
(10) lights up
29.01.2021 14:40:53 29.01.2021 14:40:53