Technical Specification - Blackstar Amplification ST.JAMES 50/EL34 Manual Del Propietário

The following external conditions will switch the Channels and Voices / Boost as
follows:
TIP RING
Closed Closed
Closed Open
Open Closed
Open Open
12. USB Audio socket
This B-type USB socket is for the connection to a computer via a suitable lead
(not supplied).
This is for USB digital audio output and for connecting to the CAB RIG software.
Again, the signal for the digital audio will be derived from the actual speaker
output via the CAB RIG technology; providing a high-quality authentic mic'd cab
response. The actual sound is dependent on the CAB RIG switch setting and the
more in-depth settings within the CAB RIG software.
More on this in the separate CAB RIG documentation.
For USB audio, standard audio drivers are used to connect the amplifier to a PC,
Mac or other applicable recording device. No specific drivers are required.
For a guide on low latency USB recording visit: www.blackstaramps.com/
usbrecording
NOTE: Always connect the amplifier via a main USB port; often found on the
rear of the computer or side of the laptop. The amplifier will appear as an audio
capture device within recording software.
14
CHANNEL VOICE / BOOST
Channel I N/A
Channel I N/A
Channel II OFF
Channel II ON

Technical Specification

ST. JAMES 50 EL34H Head
Power (RMS): 50 Watts
Valves: 2 x ECC83, 2 x EL34
Weight (kg): 6.7
Dimensions (mm): 402 (W) x 222(H) x 214(D)
Footswitch: FS-19 included
ST. JAMES 50 EL34 Combo
Power (RMS): 50 Watts
Valves: 2 x ECC83, 2 x EL34
Weight (kg): 12.8
Dimensions (mm): 535 (W) x 462(H) x 259(D)
Footswitch: FS-19 included
Speaker: Celestion G12Z-70 Zephyr
ST. JAMES 50 EL34 212 Combo
Power (RMS): 50 Watts
Valves: 2 x ECC83, 2 x EL34
Weight (kg): 16.8
Dimensions (mm): 685 (W) x 535(H) x 260(D)
Footswitch: FS-19 included
Speaker: 2 x Celestion G12Z-70 Zephyr
ST. JAMES 50 6L6H Head
Power (RMS): 50 Watts
Valves: 2 x ECC83, 2 x 6L6
Weight (kg): 6.7
Dimensions (mm): 402 (W) x 222(H) x 214(D)
Footswitch: FS-20 included
15