Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Genuine Parking Distance Warning System
Audi TT Coupe / Roadster from MY 2015
Scope of delivery:
1 x Control unit
◆
1 x Buzzer
◆
4 x Sensors
◆
4 x Covering rings
◆
1 x Mounting material
◆
Required special tools, testing and measuring equipment and auxiliary equipment:
Flat-headed screwdriver
◆
Phillips head screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of spiral drill bits
◆
Forstner bit ∅ 20 mm
◆
Expanding / crimp grip pliers
◆
Measuring and cutting tool
◆
Installation process:
Note
The Genuine parking distance warning system should be installed by a qualified workshop. Incorrect installation
◆
may lead to damage to the vehicle or the parking distance warning system.
Under certain circumstances, the steps described in these instructions may vary as a result of model updates. For
◆
example, changes to wiring colours or even the fitting location should not be ruled out. Please therefore ensure
that you refer to the latest circuit diagram or workshop manual for the vehicle.
Subject to technical modifications.
◆
1.1 Painting the sensors
Page 1 - Figure 1
Note
Sensors only have to be painted in the vehicle colour if the bumpers are painted. Sensors do not have to be painted
◆
if the bumpers are not painted.
The sensors must not be cleaned with silicone remover prior to painting. Use a mild alcohol, such as industrial
◆
alcohol, instead.
The sensors can be painted in the packaging in which they are delivered as this is designed to be used as a painting jig.
◆
Additional general information concerning painting:
◆
Self-study programme No. 214/215
The figure gives an example of the covering rings -1- already placed in the correct position on the sensors -4-.
Place the covering rings -2- on the rubber membrane of the sensors -3-.
Paint the sensors -3- and -4- evenly and not too thickly the same colour as the car.
Carefully remove the covering rings -1- and -2- using tweezers directly after painting, while the paint is still wet, and
let the paint dry.
Repaint as necessary after drying, e.g. clear varnish for twin coat painting.
Note
The covering rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
1.2 Marking and drilling the installation holes for the sensors
Shut off all of the consumers, switch off the ignition and remove the ignition key.
Remove the luggage compartment floor mat from the vehicle.
ELSA; Repair Group 70
Remove the side luggage compartment trim from the left and right-hand sides of the vehicle.
ELSA; Repair Group 70
1 x Power supply wiring harness
◆
1 x Sensor wiring harness
◆
1 x Buzzer extension wire
◆
1 x Installation instructions
◆
1 x Operating instructions
◆
Pencil
◆
Centre punch
◆
Triangular file
◆
Round file
◆
Tweezers
◆
Scissors
◆
-VAS 1978- wiring harness repair set
◆
8S0 054 630
19
Publicidad
