Publicidad
Idiomas disponibles
Idiomas disponibles
1.5 Fitting the buzzer, Audi TT Roadster
Page 4 - Figure 1
Note
The buzzer -1- is glued directly onto the plate behind the rear wall cover.
Remove the rear wall cover.
ELSA; Repair Group 70
Degrease the fitting location of the buzzer -4- with a suitable cleaning agent.
Attach the buzzer -4- with the double-sided adhesive tape included in the scope of delivery.
Guide the buzzer wire -3- through the opening -arrow- into the luggage compartment.
Secure the buzzer wire -3- using the socket cable ties -2- and cable ties -1- included in the scope of delivery.
Connect the buzzer extension wire to the buzzer wire and guide it to the control unit fitting location (see page 4,
figure 3).
Attach the buzzer extension wire and the buzzer wire in the luggage compartment to the existing cables or brackets
in the vehicle using cable ties included in the scope of delivery.
Fit the seat.
ELSA; Repair Group 62
1.6 Installing the control unit and connecting the power harness, all vehicles
Page 4 - Figure 2
Note
The plugs -1- are designed such that they can only be plugged into the connector sockets on the control unit -3 - in
one position.
Plug the sensor plugs -1- according to their numbering into the associated sockets "1" to "4" on the control unit -3-
until you feel them click into place.
Push the power supply wiring harness connector plug -2- into the associated socket on the control unit -3- until you
feel it click into place.
Push the buzzer unit connector plug -4- into the associated socket "BUZ" on the control unit -3- until you feel it click
into place.
Page 4 - Figure 3
Degrease the fitting location of the control unit -1- on the rear right-hand side of the luggage compartment with a
suitable cleaning agent.
Attach the control unit -1- with the double-sided adhesive tape included in the scope of delivery.
Page 5 - Figure 1
Guide the black and red single wires to the earthing point -arrow- in the luggage compartment.
Connect the black single wire from the power wiring harness to the vehicle earthing point -arrow-.
Unwind approximately 50 mm of the harness protective tape on the vehicle wiring.
Cut the vehicle's green/red wire.
Crimp one end of the green/red wire -1- in a crimp connector -2-.
Crimp the free end of the green/red wire -3- together with the red single wire -4- of the power wiring harness in the
crimp connector -2-.
Heat-shrink the crimp connector -2- to seal it, using the hot air blower in the -VAS 1978- wiring harness repair set.
Replace the harness protective tape.
Use the supplied cable ties to secure the power supply wiring harness to existing wires or brackets in the vehicle.
Set up the parking distance warning system.
1.7 Setting up the parking distance warning system, all vehicles
Page 5 - Figure 2
To set up the parking distance warning system reverse the vehicle until it is 50 cm from and parallel to a wall.
Note
For vehicles that have a removable towing hitch, this must be fitted during set-up.
◆
To avoid errors, avoid using shiny white walls and metal objects, such as garage doors, for the set-up.
◆
Do not enter the sensor detection area -A- during set-up.
◆
21
Publicidad
