Publicidad
Idiomas disponibles
Idiomas disponibles
Airfusion BALI Installation Instructions
INSTALLATION OF LAMP (Fig. 11)
• NOTE: The GX53 lamp is pre-installed in the light kit. Follow the below if it is required to replace the lamp.
• Remove the lamp shade from the light kit.
• Replace the GX53 lamp with a new one. Do not exceed the maximum power rating.
• Install the lamp shade back onto the light kit.
NSTALLATION OF THE REMOTE CONTROL HOLDER (Fig. 12)
I
Install the holder (A) to the wall with two screws provided (B), hang up the remote by the holder.
Complete the electrical wiring according to the 'ELECTRICAL WIRING DIAGRAM' section below. (Fig.13)
⚫
Noted: The BALI fan is a DC technology fan and cannot be used with an AC wall switch. If use wall
switch, on/off toggle wall switch – only, Always leave in the "on" position and use remote.
7 | P a g e
Fig. 11
Fig. 12
Publicidad
