Sage the Barista Express Impress SES876 Guía Rápida página 23

CLEANING THE OUTER HOUSING &
CUP WARMING TRAY
• The outer housing and cup warming tray can be
cleaned with a soft, damp cloth. Polish with a soft,
dry cloth. Do not use abrasive cleansers, pads or
cloths which can scratch the surface.
STORING YOUR MACHINE
• Before storing, press the POWER button to off,
turn the steam dial to STANDBY switch Off at the
power outlet and unplug. Remove unused beans
from the hopper, clean the grinder, empty the
water tank and the drip tray.
• Ensure the machine is cool, clean, and dry. Insert
all accessories into position or into the storage
tray. Store upright. Do not place anything on top.
WARNING
To prevent damage, do not use alkaline cleaning
agents when cleaning. Use a soft cloth and a
mild detergent.
WARNING
Do not immerse power cord, power plug or
appliance in water or any other liquid. The water
tank should never be removed or completely
emptied during decalcifying.
USING THE ALLEN KEY
Over time, the silicone seal surrounding the
shower screen will need to be replaced to
ensure optimum brewing performance.
1. Press the POWER button to switch the
machine off and unplug the cord from the
power outlet.
2. Carefully remove the water tank and drip tray,
taking particular care if they are full.
3. Using a skewer or similar, clean the centre of
the screw of any residual coffee.
4. Insert the shorter end of the Allen Key into the
centre of the screw. Turn counter clockwise to
loosen the screw.
Clean centre of screw
before inserting Allen Key
5. Once loosened, carefully remove, and retain
the screw and stainless-steel shower screen.
Make note of the side of the shower screen
that is facing downwards. This will make
re-assembly easier. Wash the shower screen
in warm soapy water, then dry thoroughly.
6. Remove the silicone seal with your fingers or a
pair of long-nose pliers. Insert the new seal, flat
side first, so the ribbed side is facing you.
7. Re-insert the shower screen, then the screw.
With your fingers, turn the screw clockwise
for 2-3 revolutions then insert the Allen Key
to tighten until the screw is flush with the
shower screen.
8. Re-insert the drip tray and water tank.
NOTE
Contact Sage Service Centre or visit
sageappliances.com for replacement
silicone seals or for advice.
EN
23