Starting Initial Installation - Porsche Home Energy Manager 9Y0.915.686 Manual De Instrucciones

Starting Initial Installation

The setup wizard guides the qualified electrician
through the entire installation via individual steps.
e
To complete a step in the setup wizard, enter the
desired setting and press Next to confirm.
e
To go back one step, press Web Application
Back in the web application. Do not use the Back
button of the browser.
Information
If the installation process is interrupted, it can be
resumed by logging in again. After 25 minutes of
inactivity, the user is automatically logged out of the
Web Application.
The installation assistant can only be started as a
customer service. When logging in as a home user,
the prompt to log out follows the greeting.
1. Starting installation
e
On the start page, select Next to start going
through the configuration steps of the setup
wizard.
2. Set language, country and currency
Field Explanation
Language Select the language for Web Ap-
plication.
Country The country of use. The config-
uration settings vary depending
on country. If you enter a coun-
try that is not the actual place of
use, some settings may not be
available.
Postcode The postcode where the device
will be used.
In a future software version, en-
tering the postcode will enable a
more precise weather forecast.
This will improve the manage-
ment of solar energy.
Date and time When there is a network con-
nection, the date and time are
applied automatically.
Time zone: Has to be selected
manually.
User-defined time: Enter the
current time if the network time
is not available as a reference.
Currency The desired currency.
3. Consent to the transfer of data
Read the data privacy information concerning Web
Application of the energy manager carefully.
Starting Initial Installation
e
Select Next to consent to the data privacy infor-
mation.
Information
Legal information and data privacy guidelines with
information on third-party content and licences, may
be accessed via the link from Web Application at any
time.
4. Selecting update and backup
Automatic software updates
Information
For automatic software updates, the energy manager
must be connected to the Internet.
When this function is enabled, software updates are
installed automatically.
e
Enable Automatic software updates the func-
tion.
Automatic backup
When this function is enabled, backups are automati-
cally saved to the connected USB storage device.
1. Insert a USB storage device in one of the two
USB ports in the energy manager (USB storage
device has an ext4 or FAT32 file system).
2. Enable the function.
3. Assign password: Enter a password.
The password protects your data and must be
entered when you import or restore the backup.
Information
It is still possible to do manual backups.
57