Quick Start - LRP ANTIX S8REBEL BX3 Instrucciones

QUICKSTART
REVERSE SERVO DIRECTION
If the steering command causes the wheel to move in the opposite direction,
the steering channel must be reversed.
If the throttle command causes the vehicle to travel in the opposite direction,
the throttle channel must be reversed.
To reverse a channel, toggle the associated reverse switch.
„N" stands for normal, „R" stands for reverse.
ADJUSTING THE STEERING TRIM
With the steering trim
to adjust the neutral position of your steering
servo.
Adjust the trim so that the wheels point straight
ahead. To do this, lift the vehicle so that the front
GEFAHR
wheels are unloaded and turn the ST-TRIM control
WARNUNG
until the wheels are straight.
VORSICHT
HINWEIS
Adjust the trim while driving to ensure the vehicle is running straight.
SETTING THE GAS TRIM
With the throttle trim
When setting up the throttle linkage, the throttle trim should be set in the neutral (middle) position.
Turn the TH-TRIM control until the carburettor is in the
basic setting is reached and the brake is released.
GEFAHR
WARNUNG
VORSICHT
HINWEIS
If the throttle linkage and the servo travel of the throttle servo are not adjusted correctly, you may lose control of the car when the engine is started.
END-POINT ADJUSTMENT PER DUAL-RATE
With the rotary knob ST-DR you can adjust the steering travel symmetrically.
You can adjust the throttle travel symmetrically with the TH-DR rotary knob.
As long as you set the Dual Rate, the LED shows the DR value.
GEFAHR
After the setting has been completed for 5 seconds, the LED returns to
WARNUNG
show the battery level.
VORSICHT
HINWEIS
You can also precisely adjust the end points individually for each direction.
You can find more on this under EPA (End Point Adjustment) in the main instructions of the transmitter!
16
ST-TRIM
TH-TRIM you set the neutral position of your throttle servo.