LANCIA Ypsilon Serie Manual Del Usuario página 16

Front wheel installation
Insert the front wheel into the appropriate fork housings (forks) and tighten with the appropriate quick release device (fig. A).
Lever Pin Locking nut
Conical springs*
Fig. A
*Conical springs: position the end of the conical springs (those with the smallest diameter) in the direction of the wheel.
Insert the pin equipped with the relative conical spring inside the hub, leaving the lever on the right side of the bicycle (side
without the brake disc); insert the second conical spring and the locking nut into the pin coming out of the hub on the oppo-
site side (side equipped with the brake disc), screwing it until flush against the dropout
Close the lever towards the fork to complete the tightening operation by verifying that the lever has adequate resistance dur-
ing the closing phase (such as to leave a mark on the palm of the hand used to tighten the lever, so-called "imprint on palm")
and, after closing, requires a considerable force to be exerted to allow relative opening.
Front mudguard installation
Remove the screw located in the rear of the fork.
Insert the front mudguard so that it passes between the fork and the front wheel, then fasten it to the fork with the relevant
bracket using the screw that was removed beforehand from it
Fasten the side supports of the front mudguard to the relevant front fork brackets by removing and then tightening the screws
on the brackets (right and left side).
15