LANCIA Ypsilon Serie Manual Del Usuario página 29

CAUTION
Only use the battery charger provided or an approved model with the same technical specifications, taking care to observe
the same methods and precautions of use indicated on the charged or in the manual.
EPAC
Lancia Ypsilon Brio
Lancia Ypsilon Incanto
Lancia Estro
Lancia Genio
Make sure that the electrically power assisted cycle is switched off and the battery is switched off/disabled (if required by the
model of battery supplied with the bike).
Make sure that the battery charger, its jack and the charging port of the battery are dry.
Connect the battery charger jack to the battery charging port and then, the mains power socket (230V/50Hz).
There is a red indicator light when the battery is charging. When the indicator light turns green, it signals that the battery
charging cycle has been completed.
Disconnect the battery charger jack from the battery charging port and then, the mains power socket.
CAUTION
Using a battery charger that differs from the one supplied, which is not suitable or approved, to charge the e-bike battery may
damage it or involve other potential risks.
Never leave the e-bike unsupervised while it is charging.
Do not switch on or ride the e-bike during charging.
Keep out of the reach of children during charging. Do not place anything on top of the battery charger during use; do not
allow any liquid or metal to get inside the battery charger.
The battery charger heats up during the battery charging cycle.
Do not charge the battery immediately after use. Allow the battery to cool down before charging it.
The item should not be charging for extended periods. Overcharging reduces battery life and poses additional potential
hazards.
Do not allow the battery to completely discharge to avoid damaging it and causing it to lose efficiency.
Damage caused by the battery being left uncharged for a long period is irreversible and is not covered by the limited
warranty. Once the damage has occurred, the battery cannot be recharged (the battery must not be dismantled by unqualified
personnel, as this could lead to electric shocks, short circuits or even major safety incidents).
Charge the battery at regular intervals (at least once every 3-4 weeks), even if the electrically power assisted cycle has not
been used for an extended period.
Charge the battery in a dry environment, away from flammable materials (e.g. materials that may burst into flame), preferably
at an indoor temperature of 15-25°C, but never below 0°C or above + 45°C.
Battery charger INPUT
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
Battery charger OUTPUT
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
A. Battery charging jack
B. Power supply jack
C. Battery charging LED indicator light
28
Recharge life
3-5 h
4-6 h
4-6 h
4-6 h