Publicidad
Idiomas disponibles
Idiomas disponibles
B. Maintenance
The maintenance schedule below is a guideline. More
frequent maintenance may be required depending on water
quality, the icemaker's environment, and local sanitation
regulations.
WARNING
1. Except as specified below, only qualified service
technicians should attempt to service this icemaker.
2. Move the power switch to the "OFF" position and
disconnect power before servicing.
1. Stainless Steel Exterior - Performed by Qualified
Service Technician or Owner/Manager
To prevent corrosion, wipe the exterior occasionally with
a clean, soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off oil or dirt buildup.
2. Storage Bin and Scoop - Performed by Qualified Service
Technician or Owner/Manager
Clean the scoop and the storage bin liner using a neutral
cleaner. Rinse thoroughly after cleaning.
3. Air Filters - Performed by Qualified Service Technician
or Owner/Manager
Plastic mesh air filters remove dirt and dust from the air and
keep the condenser from getting clogged. As the filters get
clogged, the icemaker's performance will be reduced. Check
the filters at least twice a month. When clogged, use warm
water and a neutral cleaner to wash the filters.
4. Condenser - Performed by Qualified Service Technician
The condenser should be checked and cleaned once a year.
Instructions for the service technician can be found in the
Installation Manual supplied with this icemaker.
C. Preparing the Icemaker for Long Storage
Performed by Qualified Service
Technician
CAUTION
1. When storing the icemaker for an extended time or in
sub-freezing temperatures, follow the instructions below
to prevent damage.
2. To prevent damage to the water pump seal, do not
operate the icemaker with the control switch in the
"WASH" position when the water tank is empty.
When the icemaker is not used for two or three days under
normal conditions, it is sufficient to move the control switch to
the "OFF" position. When storing the icemaker for an extended
time or in sub-freezing temperatures, follow the instructions
below.
1. Remove the water from the icemaker water supply line:
1) Turn off the power supply, then remove the front panel.
2) Move the control switch on the control box to the "OFF"
position.
3) Close the icemaker water supply line shut-off valve, then
open the icemaker water supply line drain valve.
4) Allow the line to drain by gravity.
5) Attach a compressed air or carbon dioxide supply to the
icemaker water supply line drain valve.
6) Move the control switch to the "ICE" position.
7) Replace the front panel in its correct position, then turn on
the power supply.
8) Blow the icemaker water supply line out using the
compressed air or carbon dioxide supply.
9) Close the icemaker water supply line drain valve.
2. Drain the water tank:
1) Turn off the power supply, then remove the front panel.
Move the control switch to the "OFF" position.
2) Remove the insulation panel. Remove the drain plug
located on the lower front part of the ice chute. See
Fig. 10. Allow the water tank to drain.
3) Replace the drain plug and the insulation panel in their
correct positions. Be careful not to cross thread the drain
plug.
4) Remove all ice from the storage bin. Clean the storage bin
using a neutral cleaner. Rinse thoroughly after cleaning.
5) Replace the front panel in its correct position.
14
ENGLISH
Publicidad
