Operation - SATA SATAjet 3000 K spray mix Instrucciones De Servicio

Operating instructions SATAjet 3000 K spray mix
Damage from loose screws
Loose screws can cause damage to parts or result in malfunctions.
→ Tighten all screws by hand and check that they are screwed tight.
8.1. Fitting the material nozzle
The chosen material nozzle (not included in the scope of supply) must
be fitted in the air cap of the spray gun before being used for the first
time.
■ Unscrew the air cap ring, with contact protection, [3-1] by hand and
remove together with the air cap [3-2].
■ Insert material nozzle [3-3] in air cap. Pay attention to the groove align-
ment with the fixing pin.
■ Screw on the air cap ring with contact protection together with the air
cap and material nozzle and tighten by hand.
8.2. Installation of the reversing nozzle with knob
■ Unscrew the air cap ring, with contact protection, [4-1] by hand and
remove together with the air cap [4-3].
■ Insert the sealing unit [4-4] in the air cap in the right position.
■ Insert the reversing nozzle with knob [4-2] in the air cap.
■ Position the air cap ring with contact protection, together with the air
cap, material nozzle and sealing unit, then screw on by hand. Heed
the position of the reversing nozzle with knob to the sealing unit when
screwing on.
9.

Operation

Damage from loose screws
Loose screws can cause damage to parts or result in malfunctions.
→ Tighten all screws by hand and check that they are screwed tight.
Attention!
Note!
Attention!
EN
35