Troubleshooting; Corrective Action - SATA SATAjet 3000 K spray mix Instrucciones De Servicio

Operating instructions SATAjet 3000 K spray mix
Attention!
Damage from incorrect cleaning tool
Never use unsuitable objects to clean clogged holes. Even the tiniest
damage can influence the spray pattern.
→ Use SATA nozzle cleaning needles (# 62174) or (# 9894).
Note!
In rare cases, it may be necessary to dismantle some parts of the spray
gun to clean them thoroughly. If dismantling should be necessary, this
should be limited just to the parts whose function brings them in contact
with the material.
■ Purge spray gun thoroughly with thinner.
■ Clean air cap with a paint brush or brush.
■ Lightly grease moving parts with high performance grease.

12. Troubleshooting

Malfunction
Spray gun drips
Paint leaks at the
paint needle (paint
needle seal)
Sickle-shaped spray
pattern
Drop-shaped or oval
spray
Cause
Foreign body
between paint needle
and material nozzle
prevents sealing
Self-adjusting needle
seal defective or lost
Horn bore or air circuit
clogged
Material nozzle pintle
or air circuit contami-
nated

Corrective Action

Remove paint needle
and material nozzle,
clean with thinner or
insert new nozzle set
Replace paint needle
seal
Soap in thinner, then
clean with SATA nozzle
cleaning needle
Turn air cap through
180°. If symptoms per-
sist, clean material noz-
zle pintle and air circuit.
EN
45